EGW Trijicon RMR Sight Mount for Kimber Fixed

Mounting Hardware is Included

This mount fits:
Kimber 1911's with Fixed Rear Sights
Desert Eagle 1911G*
Desert Eagle 1911C*

This mount does not fit:
Kimber Micro
Kimber Micro 9
Kimber Micro 380
Kimber Rapid

The mount is meant to be centered in the slide. The hole for the set screw on this mount is drilled off-center intentionally. This is to allow the set screw to be tightened against the bottom of the dovetail cut in the slide. This creates an upward force on the dovetail of the mount. The set screw is not intended to go in the hole in the slide.

*This mount will require a decent amount of fitting to work with the Desert Eagles and is NOT a drop in part on that application.*

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Save $20 and get free shipping when you purchase a Holosun Sight with this mounting plate!

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE407C X2 / HE507C / HE507C X2 / HS407C / HS407C X2 / HS507C / HS507C X2, Swampfox Kingslayer / Liberty / Justice

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.