EGW Vortex Razor Ruger Auto Sight Mount

Mounting Hardware is Included

This mount does not fit the Vortex Venom or Viper, that mount is available

This mount fits:
Ruger MK I
Ruger MK II
Ruger MK III
Ruger MK IV
Ruger P85
Ruger P90-95
Ruger P97
Ruger 22/45

This mount does not fit (including but not limited to):
Ruger 5.7
Ruger P89

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.831"
Overall Width: 1.062"
Mounting Hardware: (2) 8-32 Button Head Screws, (2) 8-32 Set Screws
Red Dot Fitment: Vortex Razor, C-More STS, STS2 & RTS2, Sig Romeo 3/3Xl

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.